Very welcome to JHEMCU

Products >> FC >> 

  • JHEMCU F7BT 5V 8V DJI Air Flight Controller Dual Gyro BlueTooth
  • JHEMCU F7BT 5V 8V DJI Air Flight Controller Dual Gyro BlueTooth
  • JHEMCU F7BT 5V 8V DJI Air Flight Controller Dual Gyro BlueTooth
  • JHEMCU F7BT 5V 8V DJI Air Flight Controller Dual Gyro BlueTooth
JHEMCU F7BT 5V 8V DJI Air Flight Controller Dual Gyro BlueTooth JHEMCU F7BT 5V 8V DJI Air Flight Controller Dual Gyro BlueTooth JHEMCU F7BT 5V 8V DJI Air Flight Controller Dual Gyro BlueTooth JHEMCU F7BT 5V 8V DJI Air Flight Controller Dual Gyro BlueTooth

JHEMCU F7BT 5V 8V DJI Air Flight Controller Dual Gyro BlueTooth

 JHEMCU F7BT Dual, using STM32F722RET6 high-performance processor, ICM2689+MPU6000 dual gyroscope, switch the sensor through CLI command. Integrated OSD, built-in 5V/2A (internal power supply, receiver, LED, BUZZER and other power supply), 8V/3A BEC (camera and image transmission mode power supply, its opening and closing can be controlled by USER2), two independent BEC work separately , Do not interfere with each other, optimized circuit design, high-performance hardware, to further ensure the powerful performance of flight control. Support two camera inputs (VIN1, VI2 are video input interfaces, switch control by USER1, default VIN1 is input signal). Perfect interface definition, leaving all available interfaces. In addition, 8P and 6P 1.0MM sockets are designed to facilitate the direct input of plug lines. Built-in 16MB of on-board memory, with a recording rate of 16kHz, record flight data, in order to adjust the parameters to support 32K update frequency. A special socket interface for DJI's sky-end video transmission is reserved with a special plug line. Support Bluetooth online tuning.
 
technical parameter:
 
Model: JHEMCU F7BT Dual
 
Main control chip: STM32F722RET6 216MHz
 
Gyroscope: Dual ICM20689+MPU6000 dual gyroscope access (SPI)
 
Barometer: BMP280
 
 OSD chip: AT7456E
 
Black box: 16MB
 
LED programming: support
 
BB Ring: support
 
Input voltage: 2-6S
 
I2C interface: support
 
BEC-1: 5V/2A (internal power supply, receiver, LED, BUZZER, etc. power supply)
 
BEC-2: 8V/3A (camera and image transmission mode power supply, its opening and closing can be controlled by USER2, power on when selected)
 
Dual camera input: support (VIN1, VIN2 are video input interfaces, switch control by USER1, default VIN1 is input signal)
 
Serial control port: six channels (UART1, UART2, UART3, UART4, UART5, UART6)
 
Bluetooth: support (port UART4, baud rate 115200, name JHEMCU)
 
DJIVTX: Support reserved special socket on the sky side, equipped with special plug line
 
Flight control firmware: Betaflight
 
Goal: JHEF7DUAL.HEX
 
Conversion of hole position and shock-absorbing ball hole position: 30.5*30.5mm, φ4mm
 
Flight control size: 36*36mm
 
Weight: 7.3g

Products Category

Contact Us